
POWER PACK
MPP-24 SERIES
The MPP-24 power pack is the foundation for any low voltage lighting control system. The MPP-24 supplies low voltage power to occupancy sensors and other control devices, switching line voltage in response to signals from control devices. The MPP-24 power pack is attached to existing junction boxes or mounted into fixture wiring trays. Low voltage wiring should use at least 22-gauge wire. High voltage connections should use at least 14- gauge. Always check local building codes. After initial wiring is completed, check wiring diagrams to verify the power pack is wired correctly. Improper wiring can cause damage to the power pack, lighting system, occupancy sensor and other control devices.
SPEC
SPECIFICATIONS
PRODUCT SERIES
MPP-24
VOLTAGE
120/277VAC, 50/60Hz
BALLAST
20A @ 120/277VAC
INCANDESCENT
20A @ 120VAC
MOTOR
1HP @120/240VAC
OUTPUT
150mA @24VDC (with relay connected)
OPERATING TEMPERATURE
32° F - 131° F
CONTROL ON
12-24VDC
HOLD ON
12-24VDC
HOLD OFF
12-24VDC
MANUAL ON (MOMENTARY SWITCH REQUIRED)
12-24VDC
RELATIVE HUMIDITY
20-90%, Non-condensing
MATERIAL
ABS
WARRANTY
2 Years