
In-Wall Occupancy/Vacancy Sensor
MWOS SERIES
This Multi-Technology Wall Switch Sensor combines advanced passive infrared (PIR) and ultrasonic technologies into one unit. The combined technologies help eliminate false triggering even in difficult applications. Selectable operating modes allow the sensor to turn a load on, and hold it on as long as either or both technologies detect occupancy. After no movement is detected for the selected time delay, the lights switch off. A "walk-through" mode can turn lights off after only 3 minutes if no activity is detected after 30 seconds following an occupancy detection.
This sensor also contains a light level sensor. If adequate daylight is present, the sensor holds the load OFF until light levels drop, even if the area is occupied.
SPECIFICATIONS
PRODUCT SERIES
MWOS
SPEC
VOLTAGE
120/277VAC, 50/60Hz
INCANDESCENT
800W-120VAC, 50,60Hz
FLUORESCENT
800VA-120VAC, 1600VA-277VAC, 50/60Hz
RESISTIVE
800W-120VAC, 50/60Hz
MOTOR
1/4 HP-120VAC, 50/60Hz
ADJUSTMENT TIME DELAY
5 sec. to 30 min.
WALK-THROUGH MODE
3 min. if no activity after 30 min.
TEST MODE
5 sec. at initial power up or DIP switch reset.
PIR ADJUSTMENT
High or Low (DIP Switch)
ULTRASONIC ADJUSTMENT
Minimum to Maximum (trimpot)
LIGHT LEVEL ADJUSTMENT
100 Lux - Daylight (trimpot)
OPERATION TEMPERATURE
32° F - 131° F